Structural silicate paint KS STRUKTUR 9L

• For interior and exterior works
• For painting mineral surfaces
• To achieve a fine-grained surface texture and to hide minor finishing defects
• Contains fine-grained quartz sand and marble chips
• For repainting surfaces painted with lime, lime-cement, cement, and silicate paints
• UV resistant
• Ecologically clean
• High water vapor permeability
• With additives against mold, algae, and moss
• White and tintable
• Full matt
• Non-flammable
• For interior and exterior works
• Tintable to bases A, B, and C

Surface preparation:
Previously unpainted surfaces should be cleaned of dust, dirt, and oil. Coagulated particles and salts should be removed with a wire brush or pressure washer. Prime the surface with primer KSg or KSp. Cover areas not intended for painting (metal surfaces, window frames, glass, etc.). It is not recommended to use on surfaces previously painted with alkyd, acrylic, latex, or silicone paints. Work process:
Fresh concrete surfaces must not be painted before 2–4 weeks after construction work is completed. Painting can begin 12 hours after priming. The temperature of the substrate and air must be at least +5°C during priming and drying, and the relative humidity must not exceed 80%. Do not paint in direct sunlight or in rainy and strongly windy weather. Apply to the surface using the “wet-on-wet” method with a special texture paint roller, preferably in 2 coats. Do not take breaks longer than 5 minutes during painting to avoid streaks and spots caused by drying. Depending on the desired texture, the paint can be applied in several layers, with an interval of at least 12 hours between each coat. Drying time at 23°C and 50% relative humidity is 12 hours. Due to its high water vapor permeability, the paint is especially suitable for finishing facades insulated with mineral wool and for lime and lime-cement plasters.